Board to Board Mating Connectors for BC090

Filter

• Mount Type
  Termination method of soldering connector onto PCB.

  • Surface mount2
  • Through hole1
• PCB Orientation
  Defines the orientation which a connector sits on the PCB. Vertical (straight) is 90° to the PCB, right angle (horizontal) is 180° to the PCB. Use the appropriate mating connector pairs for parallel, co-planar and right angle PCB mating configuration.

  • Right angle1
  • Straight2
• Number Of Rows
  Defines PCB connector number of rows. GCT offer single in line (SIL), dual in line (DIL), triple in line (three rows) and quad in line (four rows) options.

  • Single3
  • Dual
  • Triple
  • Quad
• Socket Entry Type
  Searches female connectors only and displays whether header pins may enter from above (top entry), from below with appropriate holes in PCB (bottom entry) or from both above and below (dual entry). See drawings for details of PCB layouts required for bottom entry connector mating.

  • Dual entry1
  • Top entry1
• Locating Peg
  Plastic locating pegs to hold the connector in place during solder process and may provide extra strength post soldering. Also known as plastic post.

  • With
  • Without3
• Profile
  The profile of connectors above the PCB. Vertical connectors denote the stacking profile in parallel PCB applications, right angle connectors denotes height above the PCB.

  • 1.00mm to 1.99mm1
  • 2.00mm to 2.99mm2
  • 3.00mm to 3.99mm
  • 4.00mm to 4.99mm
  • Over 5.00mm