Mod Jack Connectors

Filter

• Category
  The Category determines the transmission frequency and throughput of the cable / connector. There are 6 variations currently:
  

  • Category 3 - Introduced in the early 90s, uses a single pair of copper wires, still used in two-line phone configurations. Speeds up to 10Mbps.
  • Category 5 - Superseded Cat 5 in early 2000s for data transmission, uses two pairs of copper wire. Speeds up to 100Mbps.
  • Category 5e - Similar to Cat5 in appearance, uses four pairs of copper wire which are twisted more tightly and shielded to eliminate interference. Speeds up to 1Gbps.
  • Category 6 - Usually used for back-end networking. Speeds up to 10Gbps.
  • Category 6e - An enhanced version of Cat6, Cat6e has better shielding and a higher operating frequency of 750MHz. Speeds of up to 100Gbps.

  We currently offer Category 3 connectors.

  • Category 315
• Mount type options
  Termination method of soldering connector onto PCB.

  • Surface mount5
  • Through hole10
• PCB orientation options
  Defines the orientation which a connector sits on the PCB. Vertical (straight) is 90° to the PCB, right angle (horizontal) is 180° to the PCB.

  • Right angle15
  • Vertical9
• Number of positions
  The maximum number of potential contacts. The position may not have a contact dependant on whether the position is loaded.

  • 42
  • 67
  • 86
• Positions loaded
  The number of positions that have a contact available. Positions may be empty dependant on application requirements.

  • 21
  • 45
  • 67
  • 86
• Shielding
  Shielding offers protection from EMI interference.

  • Shielded1
  • Unshielded14
• Panel Stop
  Prevents the connector moving through the panel.

  • With panel stop9
  • Without panel stop9
• Latch style (right angle)
  The position of the latch, normally at the top or the bottom

  • Inverted (latch top)7
  • Inverted Offset (latch top)1
  • Standard (latch bottom)7