DC Jack Connectors

Filter

• Jack Pin Ø
  Defines the diameter of the jack male pin. Note the appropriate 'mates with plug' filter below.

  • 0.65mm
  • 2.00mm
  • 2.35mm
  • 2.50mm1
• Mates With Plug
  Defines both the inner (ID) and outer (OD) diameter of the mating plug, which is not supplied by GCT. These dimensions define which jack types mate with the plug you are seeking.

  • 0.70mm ID - 2.35mm OD
  • 2.05mm ID - 5.50mm OD
  • 2.40mm ID - 5.50mm OD
  • 2.55mm ID - 5.50mm OD1
• Jack Cavity Ø
  Defines the cavity diameter of the jack, the jack cavity should be larger than the mating plug outer diameter (OD).

  • 2.80mm
  • 5.30mm1
  • 6.30mm
  • 6.40mm
  • 6.60mm
• Mount Type
  Termination method of soldering connector onto PCB. Through hole (TH) or surface mount (SMT).

  • Surface mount
  • Thru Hole1
• PCB Orientation
  Position of the connector mating face relative to the PCB. Vertical (straight) is 90° to the PCB, horizontal (right angle) is 180° to the PCB. Upright/flag types have the connector mounted on its side.

  • Horizontal1
  • Vertical
• Shielding Options
  Shielding offers protection from EMI interference.

  • Shielded1
  • Unshielded
• Current Rating
  Defines maximum current carrying capacity each DC jack is suitable for.

  • 2.52
  • 5.05
  • 7.01
  • 8.01
• Locating Peg
  Plastic locating pegs used to hold the jack in place during solder process and may provide extra strength post soldering. Also known as plastic post.

  • With locating peg1
  • Without locating peg
• Switch Type
  Defines the number of conductors and contacts in the switch circuit.

  • 2 conductors / 2 contacts1
  • 2 conductors / 3 contacts